Fits devices with Protective Boot (EDA10A-RB-0) and without Rotating Hand Strap (EDA10A-HS-1PK). Easy-switching system. 2,5A charging. With AMPS, VESA 75 holes.
The active holder is to be connected inside the dashboard. It provides a discreet and neat installation without any cables hanging over the interior. Safe and convenient! 12/24 Volt. The product is E-approved. Connect the power cable with a 2A fuse. 2,5A charger. Charging via pogo plug. Professional installation recommended.
This holder is to be used when you want to have your unit extra securely in place and still have it easy accessable.
Easy-switching system:
The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.
- Car/Indoor Active holder
- Mobile device type: Tablet/UMPC
- Screw mount
- VESA mounting
- Built-in charger
- Black
| Design | |
|---|---|
| Type | Active holder |
| Mobile device type | Tablet/UMPC |
| Proper use | Car/Indoor |
| Device mount type | Screw mount |
| Product colour | Black |
| Compatibility | Honeywell EDA10A |
| Ergonomics | |
|---|---|
| VESA mounting | Y |
| Maximum VESA mount | 75 x 75 |
| Power | |
|---|---|
| Built-in charger | Y |
| DC voltage range | 10 - 30 |
